แบรนด์สินค้า 
Turbosound iQ18B
โปรโมชั่นพิเศษสุดยังลดราคาได้อีก โทร. 085-6383516
3,000 Watt 18" Powered Subwoofer with KLARK TEKNIK DSP Technology, Speaker Modelling and ULTRANET Networking
The 3,000-Watt iQ18B is a front loaded 18" powered subwoofer ideally suited for a wide range of portable and fixed installation, music and speech sound reinforcement applications. The high excursion 18" low frequency driver with double suspension low mass 4" voice coil provides fast and accurate transient response for virtually distortion-free operation – even in the most demanding performances.
Equipped with a very efficient and lightweight KLARK TEKNIK Class-D power amplifier, the iQ18B provides an impressive 3,000 Watts of output power. A high degree of control over the loudspeaker system’s performance is managed by a sophisticated, but easy to use KLARK TEKNIKDigital Signal Processor (DSP), which provides dynamic EQ and transparent limiting for the utmost punch and definition at high output levels – and long-term reliability. iQ18B’s advanced DSP speaker modelling presets include detailed and accurate models of some of the audio industry’s most-respected speaker systems.
On the rear panel amplifier module, you will find a fully featured user interface consisting of an LCD display, the Channel A/B gain control, and a single rotary encoder for intuitive access to level, EQ, Speaker modelling, and Feedback Control (FBI). In addition to the two combination balanced XLR/ jack inputs and balanced XLR outputs for powered satellite loudspeakers, the iQ18B features a mic/line switch and level control with signal present LED.
The iQ18B also features our proprietary ULTRANET technology, which allows the use of CAT5 cables for transmitting pristine multi-channel audio signals and other information between ULTRANET-enabled products, such as digital mixers, powered loudspeakers, and personal monitor systems. This digital distribution networking not only eliminates the potential for RFI and crosstalk so common to analogue methods, but also significantly reduces the setup or installation time required. An onboard USB port provides access for remote control of the iQ18B via PC computer, as well as DSP and speaker modelling firmware updates.
The birch plywood enclosure is finished in a hard wearing semi matt black paint and fitted with a rugged powder coated perforated steel mesh grille, 35 mm pole mount to support a satellite speaker, and plated steel castors with rubber tyres. Mains power input and link output is provided via Neutrik powerCON* connectors.
Specifications
| Frequency Response |
50 Hz – 100 Hz ±3 dB 36 Hz – 100 Hz -10 dB |
|---|---|
| Nominal Dispersion | Half Space |
| Maximum SPL | 130 dB peak |
| Crossover type | Active |
| Transducers | 1 x 18" (460 mm) LF driver |
| Limiter | Peak and rms |
| Maximum output power* | 3,000 W |
| Type | Class-D |
| Protection | Short circuit, open circuit, thermal |
| Input A / B | 2 x combo jack/XLR |
| Sensitivity | Line +4 dBu |
| Input impedance | 20 kΩ unbalanced, 40 kΩ balanced |
| Maximum input level | +21 dBu |
| Output A / B | 2 x XLR Linked to input |
| Mix output | N/A |
| Output impedance | N/A |
| Ultranet input/link | 2 x RJ45 |
| Mains Supply | Neutrik powerCON input 20A and link 15A |
| DSP |
Rotary push-encoder Buttons for PROCESS, SETUP, EXIT, ENTER |
| Mixer section |
1 x gain controls (channels A and B) 2 x Line |
| Factory EQ presets | Positioning, Sound mode |
| Display | LCD 128 x 32, blue backlit |
| Delay | 0 - 300 ms |
| Equalisation |
High and low shelving EQ 2 x parametric EQ |
| Limiter | Zero attack input limiter |
| Presets | 20 total presets, 19 user-definable |
| Crossover | Low Pass L-R 24 dB/oct |
| Protection | Lock-out function for all settings |
| Digital processing | |
| A/D conversion | 24-bit,44.1/48kHz sample rate |
| Converter type | 24-bit,delta-sigma |
| System | |
| Signal | 16 channels |
| Latency | <0.9 ms |
| Frequency response | 20 Hz to 20 kHz (+0 / -3 dB) |
| Dynamic range | typical 92 dB |
| Cabling | |
| Cables | Shielded CAT5 |
| Cable length | max. 246 ft / 75 m recommended |
| Power consumption | 200 W @ 1/8 max power |
| Voltage (fuses) | |
| USA / Canada | 120 V~, 60 Hz (T 15 A H 250 V) |
| UK / Australia / Europe | 220-240 V~, 50/60 Hz (T 10 A H 250 V) |
| Korea / China | 220-240 V~, 50/60 Hz (T 10 A H 250 V) |
เขียนข้อคิดเห็น
ชื่อของคุณ:ความคิดเห็น: หมายเหตุ: HTML นี้ไม่สามารถแปล!
ให้คะแนน: แย่ ดี
พิมพ์รหัสป้องกันสแปม:
ติดต่อฝ่ายขายโทร.085-6383516 (K.BUNG)
โทร.092-8188405 (K.KEN)
ซาวด์เอ็นจิเนียร์ โทร.081-7750013 (K.TONY)
อีเมล์:info@hengsound.com 
ห้างหุ้นส่วนจํากัด เฮงซาวด์ดอทคอม 1348/58 ซอยกาญจนาภิเษก008 ถนนกาญจนาภิเษก แขวงบางแค เขตบางแค กรุงเทพฯ10160 โทรศัพท์: 085-6383516 Fax:02-4545255 
